Towers and Platforms

MIL-HDBK-1130

Tank Level Controls. Controls such as float control valves,

a)

float-operated gauges, low level cutoffs, water detector locks,

and probes should be removed from tanks. They should then be

cleaned, treated with corrosion-preventive compound, and stored

in a dry place.

b) Valves. Water control solenoid and pressure-reducing valves

should be removed, cleaned, greased, and stored in a dry place.

Other valves, such as plug valves and check valves, should be

painted on the outside or treated with a corrosion-preventive

compound and left in place. Plug valves should be thoroughly

lubricated and left in an open position.

Meters. Meters should be removed, cleaned, treated with

c)

corrosion-preventive compound, and stored in a dry place.

Towers and Platforms. At inactivation, towers and platforms should

2.3.1.4

be inspected for structural integrity and corrosion. Any defects that could

threaten the ability of the structure to survive the inactive period should be

Fencing should be repaired in accordance with para. 2.4.1.2. Pay

repaired.

special attention to any fencing required to ensure the security and safety of

the structure.

Pools. Pool water should first be dechlorinated. The pool should

2.3.1.5

then be drained, cleaned, and if possible, covered to prevent the accumulation

of dirt and trash. Mechanical and other pool equipment should be withdrawn

from service and preserved against deterioration in accordance with the

instructions for similar equipment. Be sure that the security fencing and

gates around the pool are repaired, as necessary (see para. 2.4.1.2). The

gates should be locked to prevent unauthorized entry to the pool area and

possible injury.

Tanks, Towers, and Platforms Reactivation

2.3.2

Water Storage Tanks. It should be determined whether the existing

2.3.2.1

water supply and treatment systems are adequate for demand. Once it is

determined that the water supply system is adequate, all parts of the system

that were inactive should be disinfected and flushed according to the

provisions of NAVFACINST 11330.14 prior to reactivation. Tanks should be

inspected and repaired as necessary.

2.3.2.2

Petroleum Facilities

General. Inspect the systems and make wholly operable prior to

a)

refilling receptacles. This includes cleaning, making visual

and measurement inspections, and reestablishing permits and

licenses. MO-230 gives detailed, step-by-step procedures for

cleaning and inspection of fuel facilities.

32