MIL-HDBK-1164
Table 46 (Continued)
Inspection
Action
(1), (2)
Transmission
Change oil after 100 hours of operation.
Every 100
hours
Drain and flush, clean interior, and refill.
SA
Shaft bearings
Lubricate.
W
Drive chain
Clean, check alignment; check sprocket
M
teeth; lubricate chain and sprockets.
Agitator
If used, clean and lubricate according to
V
manufacturer's instructions.
Belt drives
Check alignment, tension, and inner cords
M
of belt drives.
Dipper and float valve
Check dipper clearance and adjust float
SA
valve setting.
Proportioning pumps
Operator's inspection
Inspect sight feeders, rate of flow, piping,
D
joints.
Feeder
Clean feeder.
W
Solution tank
Clean.
M
Linings
If cracks occur, special linings should be
A
repaired.
Overhaul
Disassemble, clean, and overhaul.
A
(1)
D-Daily; W-Weekly; M-Monthly; SA-Semiannually; A-Annually; V-Variable, as
conditions may indicate.
(2)
The frequencies shown are suggested frequencies that may be modified by
local command, as individual installation conditions warrant.
227
Previous Page
