UFC 4-211-01N
25 October 2004
20.
What will be the heaviest cfm drawn from hoses? (Quantity of outlets?)
21.
Will standard power be required overhead?
22.
Will fall protection/safety cables be required above aircraft? If so, what
type?
23.
Will fuel tank ventilation hoses be required overhead? If so, how many
and at what locations?
24.
What type and source of lighting will be preferred in the hangar? (Metal
Halide or High Pressure Sodium?) What lux (footcandle) levels are required?
(Per current IES handbook.)
25.
Will a special floor be required in the hangar?
26.
Will air start/pressurization capabilities be needed in the hangar? If so,
which locations? Please state cfm and temperatures needed.
27.
Will tail docks, wing docks, fuselage docks or nose docks be required? If
so, what utilities will be hooked up to them? Ie. 480 volt, 120 volt, compressed air
or water?
28.
What type of heating system is preferred in the hangar - floor slab,
overhead unit heaters, wall-mounted unit heaters, etc?
29.
Will door track heating be required?
30.
Will door track drainage be required?
31.
How much clear span opening width is required when hangar doors are
fully opened?
32.
Are there to be any portable offices placed in the hangar? If so, how
many and what utilities will be required including telephone, CRTs, printers and
PA microphones?
33.
What type of utilities will be required around the inside perimeter of the
hangar? Such as 480 volt, 120 volt, 208 volt, 400-Hz, compressed air, water,
etc. Please give location and capacity required.
34.
Will a PA system be required? If so, give location and number of
microphones.
35.
What type of power tooling will be mounted in hangar? Such as drill
presses, grinders, shearers, brakes, etc. In what location will this machinery be
mounted? What type of utilities will be required for operation?
36.
Will there be overhead coiling doors? If so, give location and size. (Will
72
Previous Page
